Networks

Ask something
Discussion Locked

control freak

0 helpful
15 replies

by kkelly_79

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

A little something i can't explain.
No purpose nor a reason i can think of.
Just want to know and how its done.
or just to entertain the brain.

I have 3 pc(s) running xp home through router with successful network.
I've configure my router by browser setting, not software installation due to some other difficulties. Each individual pc has been assign with their own ip address, and can connected to the internet. I've become a control freak so i'll just put it at the punchline: How can i or is there a way i can retrieve/show pc# 2&3 local area connection on pc# 1 network connection?

regards and thanks in advance

15 replies

by toivo talikka

Just a thought: has it occurred to you that you might get better overall reaction if you were to
a) rate the responses to your questions at TR fairly, and/or
b) at least bother to explain why you close the question before rating the answer?

by kkelly_79

if i insulted you in ways, i appologized, i do remember to rejecting you for 50 points. although taking advice straight from the real mind of an IT like hoz, sgt and others is alot more interesting, rather than reading them articles. i'll accept your onions this time if you promise not to geek about it.

by kkelly_79

if i insulted you in ways, i appologized, i do remember to rejecting you for 50 points. although taking advice straight from the real mind of an IT like hoz, sgt and others is alot more interesting, rather than reading them articles. i'll accept your onions this time if you promise not to geek about it.

by kkelly_79

if i insulted you in ways, i appologized, i do remember to rejecting you for 50 points. although taking advice straight from the real mind of an IT like hoz, sgt and others is alot more interesting, rather than reading them articles. i'll accept your onions this time if you promise not to geek about it.

by hozcanhan

hi kelly , it's you again . yes you can see it in 2 ways .
1. As I explained before , you install remote admin . Grab the screen of the remote pc 2&3 .
2. Buy a software ( or load shareware version ) that does network management . It will give you a table of connections . Better ones draw a schema even . For that enable SNMP of your NICs.
SNMP:= simple network management protocol .

This discussion is closed to new replies.