Question Locked

controling bandwidth usage on a cisco router?!

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello all,

i've recently set up my cisco 2811 router, to do bandwidth shaping.
i assigned 120 % of my bandwidth to users, since the possibility of everyone maxing out their bandwidth is slim, thus it gives a certain buffer for sharing the remaining bandwidth.

but the thing is, sometimes such cases do occur!
and QOS deteriorate due to the fact that i cannot pinpoint which user is eating away such huge amount of bandwidth..

so my question is, is there a way to pinpoint such user/ip. without using a packeteer!

in other words, is there a cisco IOS/command that has the ability to pinpoint bandwidth usage per ip or Access list!

i checked the web UI for the router, it just gives me the bandwidth usage per interface, anot per ip/acl as i need it to be.

any help would be appreciated:)

2 replies

by jellimonsta

You will need to configure Netflow. This will give you ability to see traffic defined by class (markings), and also drill down to see IP level traffic.

http://tinyurl.com/fgrzj

Regards.

This discussion is closed to new replies.