Question Locked

Correct understanding of NAT translation through Cisco 2821

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Here's my scenario:
WAN switch(150.121.10.50)

Current router config -
Cisco 2821 outside GE0/0 = 150.121.10.51 - connects to WAN switch
Cisco 2821 inside GE0/1 = 201.50.10.10 - connects to inside LAN switch which firewall connects to.

Firewall outside interface = 201.50.10.11

What I would like to do is remove the firewall(which is handling the dynamic NATing now - all inside systems are translated to 201.50.10.11) and simply have a few systems with internal IP address connect to the switch and which connects to the inside interface of the router. However, I would like to keep intact the same translation of all internal IP address to the one 201.50.10.11 address.

Can this be accomplished and how?

Thanks,

3 replies

by adent8888

What will be taking over the NATing if you remove the firewall? If you enable NAT on the router you would need to assign private IP's on the ge0/1 and move the 201.50.10.x subnet to ge0/0. Then you would be able to us the .11 as your PAT address for inside hosts.

This discussion is closed to new replies.