Question Locked

Corrupt boot?

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

For the past few weeks, I have noticed slow boot-up times for my Vista laptop. More recently, I have had terrible boot-ups and I can't figure out why.

I turn my computer off through Vista and it is fine. When I power up, using the power button on my machine, it begins the normal boot. I see my Dell bios screen load, then I can hear it check the CD drive. The webcam light flashes once and then the scroll lock light comes on...all of this is normal. Then the screen turns off...which is also normal. But then it just stays off and the scroll lock light turns off as well. There are five indicator lights on my machine - power, HDD activity, battery, WiFi, and Bluetooth. For a normal boot, the power light and the WiFi light are on, in addition to some disk activity. This also happens during this weird boot, even when my screen is turned off. There is clearly disk activity, but it is not responsive from my keyboard. I wait about ten minutes and manually power down.

I reboot again. This time it will either do the same thing, or it will finally load Vista and go to my log-on screen.

When I log on, the computer is fine. But after a certain amount of time, the hard drive light goes off. The computer is completely responsive, except for the random hard drive "fail." The mouse is completely responsive, but when I click on something, Explorer freezes. I have to manually power down again.

The third (or sometimes fourth) boot is usually a success. Everything loads properly and Windows is completely responsive. The hard drive works perfectly and it all runs smoothly.

But this strange boot-up is worrying me. This all happens in that same pattern too.

I am fairly confident I have no viruses. I have Malwarebytes, AVG, COMODO, Windows Defender, and Trojan Remover. I use two system maintence programs - TuneUp Utilities 2009 and Advanced SystemCare Free. I perform defrags every other week and I run the disk cleaner every week or so. Trojan Remover scans the system files and makes sure they are the appropriate size and not corrupt, so I am also fairly confident this is not a problem with Vista, but who knows.

I have tried several times to run a complete disk check, but it always goes into that nasty boot-up where the screen turns off. I am not sure if it is actually doing anything, so last night I let it sit like that, hoping it was running the disk check. When I woke up in the morning, it was on my log on screen, so who knows, maybe it did run successfully.

I looked through Windows' Event Viewer and saw some errors. I don't know much about the Event Viewer, or else I could probably just diagnose this myself. I kept seeing an error about my CD drive. Which is weird, because there is nothing in there and it works fine when I use it. Maybe this is causing the bad boot-ups.

Any input would help. Oh, I'm using Windows Vista Home Premimum on my Dell Inspiron 1525 laptop that is less than a year old. The hard drive is about 72% full and I have 4 gigs of RAM. With all of my start-up programs running, I only using about 10-13% of the CPU...so clearly I am not overclocking my system or anything.

Any thoughts or suggestions would be great...I'm at a loss!

6 replies

by robo_dev

My guess is that either your hard drive is failing, or the system is overheating.

Before you do anything, make a full backup of your data and, if possible, make a ghost image of your hard drive.

Assuming that was done, the next thing I would do would be to go to the Dell website, and check for system bios updates, hard drive bios updates, and Vista driver updates related to system or hard drive.

Next I would go into bios setup, and reset it to factory defaults. Then go back into bios setup and set it so your HDD is the first boot device. It is remotely possible that the CD-ROM drive is the problem, and setting the hard drive to go first will help.

I would assume Dell has some diags for that machine...find them and run them.

Finally, if all that fails, download and burn a Linux live-CD like ubuntu. If the laptop runs great on a linux Cd-distro, then you know your CD-ROM and motherboard are good. This would mean either you have a bad hard drive, or something weird is happening with the OS.

by mheppner1

Wow, thank you. Great reply...I appreciate it.

After looking into the problem more, I checked to see if my HDD was "dirty" or "clean." Dirty obviously meaning that there are bad clusters or sectors on the disk. Sure enough, it was dirty. But of course, I could not get the chkdsk to run on the reboot.

I had to be able to run chkdsk while booting directly to a command mode, so I used the recovery CD, booted from it, and got into the command prompt from there, where I ran chkdsk with the /r setting. There were a few clusters that were bad, which it fixed.

I rebooted, and everything went like usual. When I got to the log on screen, I had an error window that said "the file or data in c:\$Secure is corrupt and cannot be accessed. Please run chkdsk to fix the error." I don't remember the exact message, but it was something like that. After Googling what the $Secure folder was, I came to another wall.

The official answer, from Microsoft, was that the master table file (MTF) of my hard drive was damaged. Their solution was to backup, reformat the hard drive, and do a clean install of Vista.

On the forums, other people swore that the hard drive was about to get fried. They said that if the $secure goes completely corrupt, I would not be able to even access my data. Others said it was a big issue when they installed IE7, or if they were using Nortan Antivirus. So I got two completely different answers...one side said it was a hard drive going bad, the other side said it was a software/hardware complication. I don't know what to believe.

I ran the chkdsk /r again from the command prompt on the recovery CD. It found no errors. I rebooted and the C:\$Secure error was gone. Everything worked fine.

I bought Acronis True Image to back up my data. I installed it and of course, it makes you reboot to complete the install. I did so, but I got the black screen again.

...Which puts me back to my original problem.

If anyone has any other suggestions, that would be awesome. If not, I'm just going to back up everything, reformat, and reinstall Vista.

Heck, maybe I will just use Xubuntu or Linux or something.

Regardless, I do not think it is a failing hard drive. It works fine now. It is still rather slow when it loads Vista (or simply loading the log-on screen). All of my data is there and can be accessed just like before. Of course, I did run the SFC after I ran chkdsk in the command prompt. It didn't report any missing files, but then again, I'm not sure if it does report them.

The bios has been reset back to the factory default settings. When you load the Vista Recovery, it also checks your bios. It said my configuration was not correct, so I told it to fix it, which it did. All it did was rename the partition that has the recovery part on it (you know, the D:\ drive that is only 10 MB). The boot order was still as what I had set before, so I don't know what it reset. Regardless, it still boots to the black screen and it still does the same sequence that I have to shut down, reboot, blah blah blah.

I've hit another wall. Oh well, rebuilding the entire hard drive and installing all of my files will be fun, right?!

by mheppner1

I caved in and contacted Dell Support. The guy was kind of a jerk, but I expected he would be because I talked to him at 4:45 PM, probably just before he was going to get off work. Anyways, I told him what was going on and he did his little magic thing and looked it up. He said the $Secure was a software error and the best way to fix it would be to reset the computer to the factory default settings. Duh.

He said there is a menu option if you press F12 during start-up (F12 gives you options for booting up, like which drive to boot from). Last I remember, that's not on there, but I'll check again.

For the past 12 hours, I have been backing up data onto my other computer and my web host, so I haven't had a chance to try out the factory reset. They said that it completely erases the drive, so it sounds like a reformat, but that doesn't make sense because it is working out of a partition of the single hard drive, not loading from a CD or anything. Tricky...

But I'll give it a shot tonight and see if it improves anything. If not, I will be extremely pissed and will be contacting Dell to ship me a new hard drive. I still have my warranty for a few more months...might as well get my money's worth!

This discussion is closed to new replies.