Discussion Locked

CR ROM NOT WORKING PROPERLY

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I HAVE 2 COMPUTERS 1 WIN 98 1 WIN NT 4.0
BOTH W/ SAME PROBLEM. I GET ERROR MESSAGE
"F DRIVE IS NOT ACCESSIBLE DEVICE IS NOT READY" THE DEVICES ARE NOT SHARED ON NETWORK
WHEN I CHECK THE PROPERTIES IT SAYS DEVICE IS WORKING PROPERLY. I'VE DELETED DRIVERS AND RE INSTALLED TO NO AVAIL. ALL DRIVERS SEEM OK STILL NO CD ROM ANY SUGGESTIONS?

3 replies

by jeffryg

Assuming you have verified the IDE cable is connected properly & the drives are set as master/slave correctly then I would suggest going to the properties of the drive & checking the settings such as; DMA (direct memory access), Disconnect drive, auto insert notification, ect. See which ones are checked & try changing those around. Last resort see what your BIOS shows. good luck

by dar3363

THE CD ROM WAS WORKING IT WAS PREVIOUSLY INSTALLED AND ALL WAS OK
THERE IS PROBABLY A SOFTWARE ISSUE

This discussion is closed to new replies.