Desktop

Ask something
Discussion Locked

crash hard

0 helpful
5 replies

by marshoot

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I put togetheir a P4 1.9 gig on a D450WN intel MB.
I had WINXP with a 60gigHD. and AGP Card. THe system worked fine for about two weeks. I also add a KVM switch so I can acess two PC with two different OS. One mornning I turn onthe monitor and the screen was frozen. I could not reboot. I had to do a hard boot. I first time it went to the default P4 Screen and stopped. The second time it went dead. No picture. All the fans start up. No Post NO HD.

5 replies

by thechas

It is possible that the CPU or RAM has failed.

Make sure that all cards and cables are seated fully.

If you have a voltmeter, check all of the power supply voltages on the ATX connector.

If possible, check the on-board voltage regulators.
Chas

by zlitocook

Disconnect the cable from the cdrom and try booting. Try removing the cable from the hard drive next. Remove all cards except the video and the memory. If you can borrow a post card try it next to see where its stoping at. But try the cdrom or cdrw first.

This discussion is closed to new replies.