Discussion Locked

Crash on MS Backup, ScanDisk failure?

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Only trainee techie, but had real problem: Tried to Backup Office Desktop (stand alone) PC (Athlon 1GHz, 256M RAM, 40G HDD) running '98, prior to upgrading to 2000. No Tape backup available, so backed up onto C: (39Gbte avail.. Bakup copies files OK but crashed 98% of Verification. Thenceforward would only start in Safe Mode. Tried many things, but finally had to re-install '98, which worked fine, but therafter insisted on ScanDisk Surface scan on every boot, which also crashed on 2%. System stable if ScanDisk skipped. Anyone have any suggestions?

4 replies

by pummarola

What are you trying to accomplish at this point? It sounds like some disk sectors have been marked as bad, although it's very possible they are not.

First you can try using another disk diagnostic tool that will give you a more thorough analysis and provide you with more useful information. I usually use SpinRite, which I believe is the clear favorite.

If you are trying to get the system to run stable I would say the most certain solution would be to perform a complete reinstall.
1) Use fdisk to delete all partitions
2) Reboot and use fdisk to create one or more new partitions
3) Reformat the partition(s)
4) Reinstall the OS and software

When I've had problems running backup, I usually try to break it down into sections and back up up portions of the disk separately. Sometimes this solves the problem without doing anything else, other times it helps you narrow down the problem area.

When necessary (usually for extremely large installations), I usually break the backup into 3 parts:
1) The \Windows directory (+registry)
2) The \Program Files directory
3) Everything else

I assume that you are cleaning up the disk before even running the backup. One of the important things to do is clear your browser cache, because it often contains extremely long filenames and directory names that cause problems. I would also wipe out the files in \Windows\Temp and anything else that you don't need.

Good luck.

by pummarola

What are you trying to accomplish at this point? It sounds like some disk sectors have been marked as bad, although it's very possible they are not.

First you can try using another disk diagnostic tool that will give you a more thorough analysis and provide you with more useful information. I usually use SpinRite, which I believe is the clear favorite.

If you are trying to get the system to run stable I would say the most certain solution would be to perform a complete reinstall.
1) Use fdisk to delete all partitions
2) Reboot and use fdisk to create one or more new partitions
3) Reformat the partition(s)
4) Reinstall the OS and software

When I've had problems running backup, I usually try to break it down into sections and back up up portions of the disk separately. Sometimes this solves the problem without doing anything else, other times it helps you narrow down the problem area.

When necessary (usually for extremely large installations), I usually break the backup into 3 parts:
1) The \Windows directory (+registry)
2) The \Program Files directory
3) Everything else

I assume that you are cleaning up the disk before even running the backup. One of the important things to do is clear your browser cache, because it often contains extremely long filenames and directory names that cause problems. I would also wipe out the files in \Windows\Temp and anything else that you don't need.

Good luck.

by kenlea1

Wanted to avoid radical solutions like re-formatting, although this would indeed solve the problem. Did source second HDD, clean-installed '98 and copied over all files from original. However, some original software not available on CD to re-install, and failed trying to reinstall internal modem on new drive. Time constraints meant I could do no more than revert temporarily to old, possibly corrupt but working old drive.

This discussion is closed to new replies.