Question Locked

create an NTFS partition on reformatted SCSI drive

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I replaced a 36GB SCSI drive on my system with a 74GB SCSI drive. The replaced drive did not have the OS on it (F:\). It shows up in the Disk Management Window from the Control Panel, but has no drive letter. How do I create an NTFS partion and assign a drive letter.

3 replies

by oh smeg

In the Drop Down Menu chose Format and then just allow the drive to format. If necessary you can change the drive letter after the format is complete by right clicking on the drive left click on change Drive Letter and then select the new drive letter.

Col

by bbusk

When I first installed this drive, I did a low level format using the Adaptec SCSI utility offered by pressing CTRL+A before the system boots. Since the drive is 74GB, it took over an hour. When done, the only place I could see it was with the disk management folder under computer management in the control panel. I could do nothing there so I used the XP Pro install CD to create a partion on on the drive. When that was done, I could use the drive and it had the drive letter (F:\) that I wanted, but it has a "Pagefile.sys" that's using over 3GB and I can't delete it. The C:\ drive has the same thing. I don't need two, do I? How can I get rid of this junk?

This discussion is closed to new replies.