Question Locked

Dead Motherboard

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I recently asked a question about my Disk Drive. It was disconnected from my motherboard when I had tried to add some new hardware to the computer, and I received an answer from one of the community to check the Data Lead on both sides of the chain, the drive and the motherboard. I had accidentally left my computer on when I tested the cable, and it had messed up. I turned it off to reset it, and when I turned it back on, it wouldn't work, all it did was give one long beep. I called my friend's father who is a computer repair proffesional and asked him to guide me through fixing the problem. We disconnected all the hardware from the motherboard and that didn't work, so we changed the jumper settings. Still the beep, so we decided to return the jumper to it's original settings, and then the real problem started: the computer would not turn on at all. He said that it was supposed to turn on then off, but it wouldn't even turn on. Sometimes the fans will start, then immediately stop. I have no idea what I did wrong and I don't know what to do. I am currently using my grandfather's computer to post this and do what I need to do. Please help me in any way possible.

6 replies

by rob miners

I would give the inside of the case a blowout with compressed air. When blowing air through the fans make sure that you physically stop them from spinning, as they may generate power and blow something up. Remember to to ground yourself by placing the back of your hand on the Power Supply Unit and not moving your feet. By not taking this precaution it is possible that you could inadvertantly cause damage to the PC from an electrostatic discharge. Then remove the Heatsink, giving it a thorough clean and reseat the CPU applying new CPU grease. If the Fans spin freely when you give them a spin they are probably OK. If there is resistance replace them.

Clean the golden edge of each memory stick with a soft rubber/eraser, remembering not to touch the golden edge of the memory stick. Check with one stick at a time, remembering to disconnect the power from the PC.

Test the memory.

You can test the memory by running Windows Memory Diagnostic that can be downloaded from http://oca.microsoft.com/en/windiag.asp. If problems are found replace the Memory.

Also check Capacitors around the CPU for swelling or bulging.

As the capacitor ages, its capacitance decreases while its equivalent series resistance (ESR) increases. When this happens, the capacitors no longer adequately serve their purpose of filtering the direct current voltages on the motherboard, and system instability results. Some common symptoms are:

* Not turning on all the time; having to hit reset or try turning the computer on again
* Instabilities (hangs, BSODs, kernel panics, etc.), especially when symptoms get progressively more frequent over time
* Vcore or other system voltages fluctuating or going out of range, possibly with an increase in CPU temperature as the core voltage rises
* Memory errors, especially ones that get more frequent with time
* Spontaneous reboots
* In case of onboard video cards, unstable image in some video modes
* Failing to complete the POST, or rebooting before it is completed
* Never starting the POST; fans spin but the system appears dead

Keep us informed as to your progress if you require further assistance.

If you think that any of the posts that have been made by all TR Members, have solved or contributed to solving the problem, please Mark them as Helpful so that others may benefit from the outcome. ;) :D

by thumbsup2

Chances are VERY high that you have shorted out the motherboard or the drive or both.

Your only choice right now is to take the computer to a shop that has the correct tools to test the MB for you. They would also have the capability of hooking your hard drive to another computer as a SLAVE to see if the file system and data are still there. You may have FUBAR'd it beyond recovery.

by operatorofpr

Ok, so, I was able to salvage my MB and my HDD was safe, Thank God (I ended up wiping it because I had too many OSs on it and too much crap... anyways, not the point). But, for some reason, I can't use my graphics card! I feel so completely stupid always having these problems, but this computer is old... anyways, the problem is whenever the card (NVidia, I'm not sure what model) is connected to the MB, it gives that one long beep that I hate. Whenever the card IS NOT plugged in, everything works fine. I kind of need that card because I have a few programs that need a graphics card, assumingly... Anyways, I think it is damaged, but, of course, it wouldn't show any physical signs... Any help would be much appreciated, and then I can move on...

by wanttocancel

If you have any extra funds you can find a cheap one online or you can talk to your computer repair friend to see if he has a compatible card he can give you for free or a small fee.

by older mycroft

I'm assuming (hoping) this salvage operation was carried out by a computer-repair tech? If so you must have been billed for whatever the repair was.

It's just odd that a computer tech would rescue a MB & a HDD (which you've now wiped) and not check out the entire assembly as working before releasing it back into the world.

So, what steps have been taken so far? There is always the possibility that the Nvidia card suffered the same fate as the MB did originally? But without knowing what the diagnosis was, it's hard to guess what you could do now. ;)

This discussion is closed to new replies.