Question Locked

Dead Power Supply perhaps?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hey everyone,

I'll start by saying that I'm not a hardware guy, but I built a PC from scratch earlier today with all new parts, but upon powering up my new pride and pushing the power button, no lights come on and a quick, electric *pzzt!* sound comes from the power supply before silence.

Remember, these are all new parts. Did I screw up? or does it sound like a DOA PSU?

Thanks guys-

7 replies

by older mycroft

First, check that you've not got a dual voltage PSU that's set for the wrong supply.

The buzz THEN silence doesn't sound good at all. The buzz tends to suggest the PSU [b]WAS[/b] working to some extent, but the silence might mean it ain't no more.

Some system specs would help us here, to have an idea of what you've got (or had).

by seanferd

with nothing else attached? (No cards, no peripherals.)

If it does the same then, swap out the PSU.

by willcomp

Was motherboard mounted using standoffs to prevent motherboard from contacting case motherboard tray? This might seem obvious but novice builders have been known to omit standoffs.

Also, it's good practice to install CPU, RAM, and video card with mobo on the bench. Then connect monitor, keyboard, and PSU. Use a jumper (or switch on some mobos) to power motherboard and verify that it is functional. Troubleshooting is much easier with a minimal configuration sitting in front of you where it's easily accessible.

by jdclyde

The tech (ex coworker) was building a system. MB was dead, so they take it back to the store and it is exchanged. Another dead MB, it also goes back. hmmmm. THIRD MB dead, they take the whole system in.

Turned out there was an extra standoff that was shorting the boards out.

He felt as stupid as he was......

by thechas

I have had more than a few cheap supplies fail right out of the box.

One that failed nearly the same as you describe had a part that was not properly soldered to the board. Shipping and handling fractured the poor solder fillet, and there was a resounding crackle of sparks when I powered up the supply.

With power disconnected, smell around the power supply, if you smell burnt electronics, there is a very good chance the power supply is bad.

So, if the noise definitely came from the supply, I would just change out the supply and go from there.

The best way to test the power supply is to use a power supply tester. They cost about $20 and you just plug the supply in.

One other thing to check is the setting of the 120/220 switch on the supply. If that switch is set wrong, the power supply can be overstressed and fail.

What was posted by Wilcomp and others about checking your standoffs is good advice as well.

Chas

This discussion is closed to new replies.