Question Locked
0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
This Windows XP Pro system will not boot; apparently the hard drive is defective. I can boot to a UBCD4Win successfully only if I first disconnect the internal hard drive. The jumpers are correct, the BIOS recognizes the hard drive, I have configured the hard drive as the first boot device, I have tried a different drive cable. How can a defective hard drive prevent the system from booting to a different device?
7 replies
by procomsol Accepted solution
Clarifications
by larryd4 Accepted solution
You can't configure the defective drive as the first boot device, it won't boot.
Make your CD ROM the first boot device and load the UBCD4Win CD in and it should come up.
by ---tk--- Accepted solution
your first boot device is HDD... I would jump into the BIOS and double check the boot order... Change it to CD-ROM, HDD, NA... or any order you prefer, just make sure HDD isn't first.
by procomsol Accepted solution
Sorry, perhaps I didn't make myself clear. Even if I make the CD drive the first boot device, the system still will not boot to UBCD4Win unless I first disconnect the internal hard drive. Once I disconnect the internal hard drive, the system will boot to UBCD4Win. If I boot to UBCD4Win with the internal hard drive connected, the system gets to where UBCD4Win is checking they system hardware configuration and there it freezes with a blank screen. The monitor light is green but there is no display.
by ---tk--- Accepted solution
a SATA or ATA drive?
by ---tk--- Accepted solution
I reread your original post... I scene weirder stuff in this industry... the PC might use different drivers for on board controllers. Like my system uses a promice array controller... UBCD will load but will not see any of my drives, unless I load the proper drivers in the begining. Its technically a RAID controller... but I wasnt running a RAID at the time.. who knows.... In your situation I would probably take the drive and mark it CS. Place it in another PC, make sure its seen as a secondary drive, and run chkdsk. You could also attempt to view the file system... If its the drive the Good system will def. let you know.
by procomsol Accepted solution
Yes, it is a PATA drive. I did, indeed what you suggested. I removed the hard drive from the system and connected it to another computer via a USB adapter. The files were intact and I backed up the ones I needed. I ran CHKDSK on the drive, reinstalled it in the original system and it booted successfully. However there were signs of malware (that's why the system was brought to me in the first place) so I'm doing a system recovery now. Apparently the drive is physically OK. The hard drive is not part of a RAID array and uses on-board controllers.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies