Discussion Locked

Delay printing Dos Program (Clipper)

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Why there is delay approximately 1 min printing through clipper program if print from the network? If i quit the program printing goes imediate.

3 replies

by sparent

Sounds like your print queue is waiting for an End of Print Job (End of Capture?). It's been a while since I've dabbled with Netware but you can set certain parameters on your Netware print queues to control when jobs are released to the printer. I remember that exiting the program that initiated the printer would immediately send the end of job.

by tjc

Make sure you have the printer set to "print after first page" also make sure that you try turning off and ont he spool settings and see if you get any speed up. Also if this dont' help then please list what type of networka nd what type of printer you are using.

This discussion is closed to new replies.