Question Locked

Deleted RAID 1 Volume - How to Recover

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

2 500GB drives in a hardware RAID 1 array. 2 volumes. One volume (Data)is gone.

I've run several software data recovery apps, but nothing "sees" the missing volume. Offers to restore data only from the 1st. volume.

Originally, Volume 1 was OS and Apps - 160GB.
Volume 2 was Data, 340GB.

What happened to the missing volume? I'm not sure, but I am guessing it's one of the following.

1. Accidentally deleted while thinking I was deleting a different volume. I don't think this is the case, because I belive the affected drives were disconnect at that time, but not sure.

2. Motherboard only supported 4 volumes total. Had 3 volumes (added 2 new drives) with original array with 2 volumes disconnected. Connected original 2 bringing total to 5 volumes. 5 volumes not supported, something had to go???

I am considering recreating the missing volume, but if I do that, will the data (if it is still there)be over written?

At this point I don't mind having to "recover" the data.

Any suggestions greatly appreciated.

Paul

4 replies

by bfilmfan

Was it a software or hardware RAID?

Usually on a hardware RAID, the configuration for the array is stored on both the controllers and the hard disks, so you have to go into the array controller card and actually delete the array for that to happen.

Depending on which type of array it was, will vary the answer to resolve.

by paulca

Hi BFilmFan.
I mentioned in my post that it was hardware RAID, but you could have easily missed it. I think that either I deleted the volume or the system did it because I had too many volumes connected at once.

Anyway, to solve the problem, I went into Windows and from the Intel Storage Matrix Application, I created a New Volume in the "empty" area of the two drives where the Lost Volume had been. Figuring that this would be the only way the Data Recovery software would be able to "see" the lost Data.

It Worked!! I recovered almost 300GB of lost data. Many Old Photos and Documnets I would not have been able to replace.

So, if you are reading this, hopefully you are NOT in the situation I was in, but if so, I hope my solution works for you.

Lesson learned, even though I knew better, RAID is NOT a substitute for backing up.

My new plan - Use Vista to do a full system backup to an external HD. Store that hard drive in a water proof and Fire proof box.

Back up my data to a separate external drive and keep it in the same box.

Do regular backups.

Good luck to any of you that find yourself in my mess....

Paul

by cg it

which means an exact copy of what's on 1 disk is made to the other. If one drive dies, you can rebuild the RAID array with a new drive, from the remaining drive.

What you did was rebuild the arry which restores the data from the other drive. It did what's it's supposed to do which is keep data secure. Though not a substitute for backups, it does provide reliability. If one drive dies, the system still runs until you replace the failed drive with a new one.

This discussion is closed to new replies.