Question Locked

Dell D600 Laptop DC plug on back may be broke

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
I have a Dell D600 laptop. One night I was using it and sat it down on end, on the DC adaptor. The next day I went to use The laptop, now it will only run on battery. I am guessing the plug on the back is broke, I have power to the end of the DC adaptor. Is this an easy fix? What would i ahve to do to get this repaired?

8 replies

by mjd420nova

I do believe that the connector is part of the main system board, and that would require replacement. Contact Dell and see if they will even look at it. A skilled technician could do a repair, maybe without any parts as it may have just come unsoldered from the board or just fractured the traces.

by morrelle

I have seen this many of times in my line of work, I have
replaced about 10 MBO's of people that have the same issue.
You can get this replaced for about 200.00 with the right
tech on the job.

by largo_dave

Unfortunately I have this occur about once every month at my job. Check to see if it is still under warranty (free replacement). Good luck in getting it repaired!

by clark1

You can buy the dc powerjack from any number of sources, just google dc powerjacks.

What you need to do is remove the broken part, clean out the holes and solder the new one on.
I use a jewlers magnifying glass that also has a backlight which really makes thing easier to see.

I use a small pick to clean out the mounting holes, I just heat them up with a soldering iron and immediately push the pick thru. It takes a few times to get it clean. Then seat the new one, make sure it seats correctly, I usually just put the board back in the case to check fit. Once I am sure its good, I solder it in place. Rebuild the laptop, test it and go with it.

I have done several including my own with no issues.

by mrasmussen

I just had to replace a mobo in a D610 with the exact same problem. It would not recongnize the Power adaptor properly even when we had the laptop plugged into a docking station which didnt even connect through the power jack. It would also throw up an error message on the screen saying that it need to be plugged into a 65 watt or higher power supply. We tried a few different ones, same problem.
We had a Dell tech come out and replace it in about 30 min.

by big.t.rocks

A friend of mine bought over his Dell Latitude D600 computer to me this evening. The dc power jack is loose and the computer will not run off the power supply.

I Googled some motherboard prices for this laptop, $312 was the cheapest.

ECost.com had a new D600 laptop for $367!

Found this forum tonight and the suggestions were to replace the DC power jack. I Googled DC power jacks and came up with http://www.laptopjacks.com/.

The part number for the D600 on this site was DL111500 and the cost is $39.99/ea for 1-4. I will purchase one, solder it on and see if this rectifies the problem.

This discussion is closed to new replies.