6 replies
by oregondude Accepted solution
by oh smeg Accepted solution
To mount another HDD.
If there is all that should be required is to bolt the HDD into the case after first setting the Jumper to Slave or CS [b]Cable Select[/b] and then you need to plug in the Primary IDE Lead and a Power Lead.
The Slave Drive should be connected to the Middle connector on the IDE Lead with the Master HDD connected to the End Connector and you may require a Power Splitter Cable if the PS doesn't have sufficient Power Plugs available.
After you have the HDD installed open Device Manager and right click on the new HDD which has never been used and follow the steps to format it. This may involve preparing it then formatting it or just Formating it. After this is complete you will have access to the HDD and you will need to move your Data Files to it and probably the Page File as well.
You could also Compress the current HDD which may give you some more space and help the system out here. All that you need to do to compress the HDD is to open My Computer right click on the C Drive and select Proprieties and then add a tick to the Compress Box on the left bottom of that Box.
Col
by oregondude Accepted solution
by oh smeg Accepted solution
You shouldn't need any Cables unless you only have one of the Wide 40 way Cables in your Dell that connects the HDD and Optical Drive to the M'Board.
If that is the case plug one of the IDE Leads from the HP into the Dell's M'Board on the unused Socket it may have a Black Plug on the M'Board and just plug this lead into the HDD.
You may however need to get what is called a Power Splitter which allows one Power Plug to be split into 2 or more Leads so you can plug in the second HDD.
The IDE Leads have 3 connectors on them. Generally speaking the Colored one plugs into the M'Board and there are then 2 black ones. The One on the end should go to the First HDD and the one in the Middle goes to the one you are adding.
You may be required to change a Jumper this looks like a piece of Plastic that goes over 2 pins there are 6 pins between where the Data Lead and Power Leads plug in to the HDD. If you look on the sticker on the drive there should be a Legend showing you how to set the Jumper. There are generally 3 Options Master, CS, Cable Select or Slave. It is just a matter of moving this Jumper to the necessary pins as shown on the Sticker on the HDD.
Col
by oregondude Accepted solution
by oregondude Accepted solution
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending