Networks

Ask something
Discussion Locked

dell poweredge 6300 startup problem

0 helpful
1 reply

by drag_on6 1 view

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Problem starting Windows NT server, machine runs bios, then i get an error, "plug and play config error, strike F1 to continue, F2 for setup" F2 nothing wrong with cmos, F1 runs to screen with mode selection "win NT or win NT VGA mode" wich ever onei choose tha systems stops after pressing enter and screen is blank...please help

1 reply

by johan101

ooh nasty litle problem
go into bios and tell it you dont have a PnP OS instaled and try again . if you still have problems manualy configure the hardware in the bios till it works or just pull out all cards except vga :-) and start it up - should work otherwise you have motherboard problems most probably - then plug the cards in one for one till your problems reapears and you have the troublesome card

hope you get it up and running

Johan

This discussion is closed to new replies.