Question Locked

Dell PowerVault 725N RAID Controller Problem

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello All,

I am having a problem with my Raid controller. When I boot up into my bios raid control panel, everything looks good. I have a 4 disk RAID0 array. The statues on all physical drives is OK.

The problem is whenever I try to install any operating system (Linux or Windows), the install can never find any of the drives. When I boot POST, it says it can init 1 Logical drive (the array), however when I go into the BIOS, all my IDE channels say "NOT DETECTED".

Anyone know what is going on? What on earth am I doing wrong? Thanks everyone!!

4 replies

by cmiller5400

You will need the setup disk for the RAID controller and press F6 during the setup process (it will tell you when, it may take a few tries to get it right I have found) to allow Windows to give you the option to load the correct drivers for the RAID array.

by Member 19291532

But the PowerVault 725n is a NAS device that comes with "Windows for Appliances" (A W2k variant) installed on it, stock. It isn't a PowerEdge server and doesn't work quite the same.

It also has the CERC, ATA/100 raid controller, typically, and 4 IDE ATA drives - so it is a different beast than a PERC controller based system. The RAID configuration is software based, using the Dell PowerVault RAID utility. I don't think there is anything you can do with this Raid controller at the BIOS level.

I see that they have some Linux options on Dell support for this product - which is long ago EOLed - so maybe you can get it running under a Linux.

If you can't find the original "Resource CD", which contains the W2k image, things might be pretty difficult. Dell Spare Parts may still have this - but it isn't free, and my guess is the CD will cost as much as the NAS is worth.

There may be other configurations of the 425n that I am unfamiliar with, so I'd verify what I said here against your own machine. For example, I suppose it is possible that you have a Perc controller and SCSI drives - which would probably make things a lot less difficult.

This discussion is closed to new replies.