Question Locked

Dell Precision M60 video failure

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My Dell Precision M60 laptop boots but after ca a very short while the video starts to streak then maybe will be reduced to dots and finally fails completely (blank black screen). What could the trouble be? Video chipset or what? Any suggestions?

4 replies

by ---tk---

Your graphics card could be going out... but your inluck, those cards are not inter-graded into the motherboard... meaning you can call Dell and order a new one and install it. vs. replaceing the entire mother board...

Or It could be the LCD... to check and see which one I would hook up an external display to the VGA port on the back of the Laptop...

if the external LCD works fine for a long time I would say its the LCD... but dont let it fool you... I have sceen in some cases external LCD worked fine... but the fix was still replacing the card...

My guess is the graphics card because of the symptom... it works for a while, and in a few min it messes up... meaning the card is heating up, parts are expanding, and the video goes... but call Dell, they will help you out a little more...

by robo_dev

and you see the image, then the backlight is failing (backlight inverter, lamp, etc.)

by jamesrl

Heat build up can cause the card to fail, and one of the common causes is dust. The temp of the graphics processor can build up from start up to a high temp in minutes - this would explain why it works for a time and then starts to fail.

To be sure try and get the dust out of the fans/heatsink. I used a little canned air.

James

This discussion is closed to new replies.