Question Locked

Desktop clock not in sync with server clock

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello everyone,

Last Sunday was the start of daylight savings. As of Tuesday some desktop clocks are correct while others are still off by 1 hour. Any suggestions on the best way to resolve this problem. I searched Microsoft but no luck. I am running 2003 server in a domain environment.

Many thanks.

7 replies

by bizzo

It could be that the daylight savings check for some of the desktops is off?

by mark

The microsoft updates should have fixed it, however they may not be using the correct time zone to begin with. Go to adjust date/time to verify it is setup correct. You could also use the command net time /setsntp:{Server Address} to pull the time from the server.

by chrisj

Looks like the patch did it.

Many thanks for sharing your knowledge.

by pmalaison

I am having DST issues too. I have my SBS 2000 server (acting as a PDC) serving time through W32TM. I needed to do this so that I could make sure that all my desktop were in synch with the exchange server and my VoIP server.
All machines, desktop and server, ended being 2 hours ahead of my time server. I had to unchecked the automatically adjust for Daylight saving time boxes on all the machines and resync. If I just adjusted the time, they would jump forward again at the next resync.

This discussion is closed to new replies.