Discussion Locked
0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a domain that is spread across (3) geographical locations. How do I set the remote locations in the domain so that the DHCP server handles the WAN remote locations? Each location has a router which connects back to the main office router which is the gateway router to the internet.
6 replies
Im just curious, is there a reason for the remote lans to have IP address assigned by your DHCP server at the main location?
Where I have worked, we used a local DHCP server (either an nt server or a small router) at the remote sites.
The question was auto-closed by TechRepublic
by bcbvale
On a Cisco router you can use the ip helper-address command on the interface that the DHCP client resides.
ex.
ip helper address 10.10.10.1
where 10.10.10.1 is the ip address of your DHCP server.
If you are not using Cisco routers then youwill need to consult your vendors documentation.
ChrisV
by bcbvale
Sorry the hyphen did not make it into the example.
ip helper-address 10.10.10.1
The question was auto-closed by TechRepublic
This question was auto closed due to inactivity
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
0 helpful
15 replies
Question
Is WSL still relevant in 2026?
0 helpful
1 reply
0 helpful
2 replies
0 helpful
10 replies
Question Unanswered
i need help in transferring my bulk emlx files
0 helpful
0 replies