Discussion Locked

Direct connection between WinXP and 95

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Is it possible to do a direct cable connection between WinXP and Win95 or a PC to PC file transfer? Something other than using network cards.

1 reply

by stuart_at_oz

Yes.

It is possible to get several different types of cables for this precise purpose.

the oldest type is the "Laplink" style cable, typically a "null modem" serial cable. This is wired up in a specific way to allow communication between two computers.

There is also a parallel port cable version available (not sure if this is wired specially)

Either one of the above are supported by Win 9x, but you will need to install "Direct Cable Connection" and "Dial-Up Networking" from the Windows Setup.

When you have them installed and rebooted etc., you can connect the cable to each PC, and then start one of the compters as the "server", and then the other one as the "client". (I can't remember exactly where to find the program, but I think it is under Start/Programs/Accessories/Communications)

There are also USB link cables available, but I have not used these, and I am not sure about the software under Win9x.

Also! it is possible to link using Firewire (iLink, IEEE1394, etc) assuming you have a firewire card, but again I am unsure of the Win9x suppost for it.

'Luck,
Stu

This discussion is closed to new replies.