7 replies
by j.candelaria Accepted solution
by oh smeg Accepted solution
If the HDD is faulty you'll need to replace it and recover your data from your most recent backup. However if it's become disconnected all that is required is to turn off unplug and reattach whatever has become dislodged and this may not be obvious as sometimes a Data Lead or Power Lead may look as if it's in correctly but it has moved out slightly and needs to be pushed back in.
The reason that you are getting the No HDD message is that the computer can not see the HDD so it's stopping at that stage of the Boot Process.
Col
by bnbromiley Accepted solution
Open the case and with the PC on listen to the HDD - Can you hear it spinning?
If not it's stuck and dead.
You can try putting it in the freezer over night and if it will then work clone it and put all on a new drive.
by elsanto_235 Accepted solution
Did you try putting the HDD in another computer as a slave to see if it is working. If so, check you jumpers to the front of the HDD to the specified setting (master, slave or cable select) and make sure the power cord is connected.
After doing this if it fails check you Bios settings and make sure that the IDE configuration is set to Auto if not you could always reset the CMOS and load the system default settings. Now if this fails then buy a new HDD and start all over againg. But you could always keep the other one as a slave HDD in the machine.
by steve.stanley Accepted solution
by j.candelaria Accepted solution
by r4nd0m321 Accepted solution
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending