Question Locked

Does serial link speed depends on serial cable?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

hi

i have two cisco 2811 routers. I am connecting using serial cable (smart cisco serial cable, v.35). When i enter clock rate of more than 2000000 on DCE side, link goes up and down on DTE side. But when i enter 2000000 or below, it works.

Both routers takes clock rate of upto 8000000 but link goes up and down on DTE end.

also tried different serial cable in case 1 faulty. Also tried reload but still same.

My question is does this speed depends on serial cable or IOS, other than clock rate? Am i doing something wrong?

I am suspecting serial cable is an issue.

Any reply is appreciated

regards

tk

7 replies

by seanferd

or if it isn't shielded enough for the environment, or if it is too long.

I guess one question is: Why do you need such speeds on a serial port?

I've not been able to find any appropriate Cisco documentation, so if you have it, check and make sure that the 2811 is actually capable of 2 to 8 megabaud.

If the routers are in production, could it be that they are otherwise too busy to deal with that connection speed?

Someone much more experienced than I will have more insight, I'm sure.

by oh smeg

Remember that these are listed differently to the Clock Speed of the Routers.

While it very well could be the Serial Cable it could just as easily be the speed of the Serial Ports which is your issue here. ;)

Col

by seanferd

having no experience with Cisco routers. I didn't know if that 8 megabaud was supposed to be the top port speed (I've heard of 5). If it is system clock speed being referred to, that has little to do with the data transfer rate between serial ports, all things being equal.

And I couldn't find anything from Cisco on the port speed.

by hellotaral

thanks for reply so far

i will check cisco doc for router hardware.

Another thing that i noticed is,

cisco 2800 with WIC 2A/S slot- i could not enter clock rate above 128000bps

then i changed the router to cisco 2800 with WIC 2T slot and it goes upto 2000000 bps with same serial cable of v.35 10ft cisco smart cable.

As far as i know, WIC 2A/S does not supprt more than 128k but WIC2T can support 8 meg.

Reason i am using high speed is for my experiment in lab ( not in production).

I got 15 cisco 2811 with WIC 2T slot, they all have same issue, cant enter clock rate above 2000kbps.

I will try to search more after i will finish documentation of my project.

i will get back to you

by hellotaral

thanks seanferd

i will check the module for wic-2t tomorrow and will get back to you.

This discussion is closed to new replies.