Question Locked

DoS messages in Cisco Router logs - when should I be concerned?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello,

We are having intermittent network issues (basically http traffic) and I have started troubleshooting each point to see where we might be having a breakdown.

I am seeing these logs in our Cisco 2811 router:

%FW4-ALERT_ON: getting aggressive ....
%FW4-ALERT_OFF: calming down ....

I realize these indicate half-state packets, which is a sign of a DoS attack. This is not an area of my expertise, so my question is if this is common due to the number of virii, worms, etc.. on the internet, or if this is possibly a real indication of someone who is trying to attack our router.

I refreshed the logs so I can see what is happening now.

If anyone has any hints at what to look out for that would be great. We may hire a consultant to look at this if there is some real concern.

Thanks!

5 replies

by johnm

We have a number of public computers that see a lot of activity and it turns out we were exceeding the default max open connections settings. This was also the source of our network http traffic issue.

by scottaaa8

We are experiencing the same messages and symptoms with a new 1811 router.

I am unclear as to what the solution was.

Simply increasing the max open connection settings?

by cg it

which means there are no idle session limits or there are applications that have open sessions which don't close sessions when they are completed.

The solution is to determine if the number of open sessions are legitimate and if not, make changes to so that sessions are closed when done or if idle, close the connection after a specific period of time.

Denial of Service attacks create open sessions thru large numbers of connection requests. An attack can overload and cause network congestion.

Any DoS attack should be investigated to determine whether the attack is specific to your network in an attempt to overload it. If so, then you can adjust your perimeter firewall for DoS attack protection.

by millcadz

Hi John,

Can you tell me what was your solution? I have the same problem here.

Thank you.

Regards,

Ramil

This discussion is closed to new replies.