Question Locked

double NAT with two cisco PIXs

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

hi,
can you please explain how to do double NAT with two Cisco PIXs.

Internet LAN(untrusted) LAN (trusted)
------ -------
50.5.1.2 |PIX | 192.168.1.0 |PIX | 192.168.1.0
------ -------

this is how i want to configure the network, i don't know how this should work but if i can get this explained, i can configure.
any help would be nice
thanks

6 replies

by cg it

Doesn't make sense to have 2 PIX firewalls unless your running a DMZ.

I'll give you a hint on how to make it work;

"subnets"

by lushan

what i want to do here is to hide my Trusted LAN to outside, as the outside can only see my untrusted coz they on same NETWORK, sorry im not very good at explaing this mess but banks have this system.
may be there is another network inbetween the PIXs
my trusted LAN (192.168.1.0) will be NAT ed with PIX1 and NAT ed again either by the router or PIX2.
hope this is clear. sorry guyes if this not well explained. thanks for all the reply

by jellimonsta

Putting your LAN behind a firewall will hide the inside network from the Internet. You do not want to place any hosts on the outside network, but you should place them in a DMZ.
You can then open specific hosts and port to access from the Internet (in the event of a mail or web server).

by jellimonsta

I agree with CG IT, why do you want to use 2 PIXen for what essentially amounts to an Internet connection, a DMZ network, and a LAN. All of this could be accomplished with 1 PIX.
Of course, some of this depends on what PIX you actually have (501, 506, 515, etc).
Check out this link
http://tinyurl.com/6zr76s

http://tinyurl.com/5uyrys

If you want to have hosts in an untrusted LAN this is precisely what a DMZ is for. The above link should help you accomplish this.
Regards.

[edited to fix link]

by cg it

if you really want 2 PIX firewalls in the mix then you need to create two subnets. PIX 1 is one subnet and of course PIX 2 is another subnet. as an example PIX 1 WAN link connects to the internet. If you have a static public address from your ISP you configure the WAN interface with the appropriate addressing. the LAN interface then is configured with a private addressing scheme but you use your ISP DNS servers for name resolution. For PIX 2, it's WAN interface would be on PIX 1 LAN so you configure it with a PIX 1 address again using your ISP DNS servers. PIX 2 LAN interface then is configured with a private address that is not the same as PIX 1 LAN. also use your ISP DNS server.

here's the catch, everytime you want to provide services such as http/ftp/smtp or for gaming open a range of ports for hosts behind PIX 2 you have to configure PIX 1 the same way.

2 PIX = lots more work.

This discussion is closed to new replies.