Discussion Locked

Dual boot with Win2000 Pro

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have two hardisks of capacity 6gb and 20gb. I have currently upgraded from windows 95 to Win 2000 Pro.
The 6gb harddisk has two partitions C & D drives and 20GB disk as E drive.
My file systems is FAT32.
There some files in all partitions.I would like to install Windows 98 in my system now and make it dual boot.
Now I would like to whether it is possible to install Windows 98.
If possible what are steps to install and precautions to be taken while installing.

Thanx in advance.

5 replies

by cportman

Unfortunately you have already upgraded to win2k pro. The only way to dual boot is if you install Win9x first, then run the win2k install and select a different directory for the 2000 OS. You would have to reformat and start over if you want to dual boot.

cp

by bentgellerich

Check out MS KB article #Q153762

Start the computer from an MS-DOS floppy disk that contains the Sys.com file. Sys the boot drive to MS-DOS by typing the following command at a command prompt:
a:\>sys c:
After you type this command, you receive a system transferred message when the procedure is finished.

NOTE : This command disables the Windows NT boot loader so that the computer boots MS-DOS when booting from the computer's hard disk. You must repair the Windows NT boot loader after you use the following steps.

Reboot the computer from the computer's hard disk to a command prompt and install MS-DOS on the computer if it is not already installed.

After you completely install MS-DOS and reboot, restart your computerby using the Windows NT Setup disks. During Setup, select R to repair Windows NT.

NOTE : You need to repair only the Windows NT boot sector. Do not choose to inspect the registry files, the Windows NT system files, or the Windows NT boot environment during this procedure.

After you repair the Windows NT boot sector, you need to manually edit the Boot.ini file to include an option to boot to MS-DOS. The Boot.ini file is a read-only, hidden, system file that is located in the root folder of the boot drive. Add the following line to the Boot.ini file under the operating systems section:

c:\="Microsoft DOS".
The next time that you reboot the computer, you have an option to choose MS-DOS on the Windows NT Start menu.

You can use the procedure in this article to enable dual booting between Windows NT and Windows 95. To dual boot Windows 95, boot the computer to MS-DOS and install Windows 95. A Windows 95 installation is Windows NT-aware and does not overwrite NT boot loader information when you use this procedure.

This discussion is closed to new replies.