Question Locked

DVD ROM and DVD Write Drives suddenly stopped reading and writing at high s

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Both my DVD-ROM(Drive"F") and my DVD Lightscribe Writer(Drive"E")stopped reading/writing at high speed last week,apparently at the same time.I can't do high speed copying between drives or even high speed burning from the hard drive on the DVD writer(HP-840).The PC is an HP m7360n Media Center. Please Help!!!-Thanks,"Mac".

5 replies

by seanferd

Have you changed any hardware connections?

Is the media you are using rated for the speed you are attempting to use?

by machobbs

The only hardware changes occur when I swap ext. USB hard drives. I use good quality media,mostly Verbatim and HP.To a lesser extent I use Memorex,Sony,Philips and Maxell media.Usually I use Nero to write or dub,but when a blank disc is inserted the program tells me the max. write or dub speed is 2.4X.It no longer lists the 4X,6X,8X,12X or 16X choices,although I never write or dub above 6X speed.

by seanferd

it comes in different writable speeds. If this is the case, and you have a lower speed writable media, the drives and software autodetect this and won't list anything higher.

by natureislandtech

hi mac from my exprience its a setting in ur hard wear go in to control panel click on device manger then look for the dvd drive and then on top to your right click on an icon with a magnifying glass in front of a pc monitor when u get there it will ask you to scan for issues for that hard wear RUN THE SCAN if that dont work check your burning soft wear if that dont work change the drives thay are worn out let me know. MALCOLM

This discussion is closed to new replies.