Question Locked

Easylink Advisor Wizard...Currently not connected to the internet

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I used Easylink Advisor Wizard to install my WRT54G Wireless-G router, after the message "configuring your computer" for a few seconds then pop a new message "Currently not connected to the internet"

How come I'm not connected to the internet coz while Installing the said router I'm also surfing arround and checking my mails....please somebody help...

4 replies

by thumbsup2

... Especially the ones about how to plug in the cables.

If you are surfing, your computer is directly connected to the internet through some sort of modem (DSL, Cable, whatever) instead of being connected to the router. So, is the router connected to the modem at all?

If your ISP limits your connection to only one computer, you may need to have the router clone your MAC address which again means the computer you're surfing with must be connected to the router and not to the modem.

by casiora

Thanks for the Tip THUMBSUP2.

Here's my connection before I started to configure:->"DSL Modem connected to Router(internet labeled hub)" then "router(hub number 1) connected to Laptop"

Then that's the time I started to configure WRT54G router using Easy Link Advisor which is my big probs regarding its message that there's no Internet connection.

by seanferd

If you have internet connectivity, you have obviously set up your computer-router-modem network successfully. You apparently did just fine without LELA, which produces odd problems like this, even when everything is operating normally.

Your specific issue:
http://forums.linksys.com/linksys/board/message?board.id=EasyLink&thread.id=2654

Main forum board:
http://forums.linksys.com/linksys/board?board.id=EasyLink

Generally, it works fine for some, not at all for others, and there is no apparent support for it.

Again, you've obviously managed just fine without extra software on your system. Router configs are actually pretty easy through the router's interface, if you need to change anything.

This discussion is closed to new replies.