Question Locked

Entry Point Not Found

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

The following Blue Screen message is appearing on an NT 4.0 SP6 machine at boot. Any ideas?

STOP: c0000139{Entry Point Not Found}
The procedure entry point RtlGetVersion could not be located in the dynamic link library ntdll.dll.

5 replies

by w2ktechman

If it is it may be either corrupt, or was somehow unregistered.
Try re-registering the dll file,
regsvr32 %path%\ntdll.dll

if it will not register, the file may be corrupt, replace it.

by itbloke

Since my original post I have found that the file is not there in system32. I have booted the machine using NTFS4DOS and tried to copy the file "copy ntdll.dll c:\winnt\system32" using the NT CD but get the message "unable to open .ntdll.dll. How can I copy the file onto the C: drive?

by w2ktechman

that NTFS4DOS is a read only program, isnt it? In this case the (expensive) ERD Commander would work fine.
You should be able to use the Win cd to repair.

This discussion is closed to new replies.