Discussion Locked

Error

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have just installed 98SE on a K6II 500cpu, on a amptron board with 64MB ram with evrything on board. I keep on getting this fatal error "0028:C0005338 in VXD VMM(01) + 00004338. Current programm will close, press anykey to continue" Has any of youguys ever encounter this problem?

6 replies

by maxwell edison

Greetings,

With Windows 98, there might be several causes.

A very likely cause is an incorrect setting in BIOS. Enter your computer's BIOS, go to the "PNP/PCI Configuration" section and change the "Plug and play Os installed" setting to "No".This cause/solution was seen on a Soltek Motherboard with an AMD 500MHz CPU running win98se. It could apply to others.

It is very likely that this is caused by overheating of the CPU. Check the CPU fan to make sure it is working, if it is you might try changing to a more powerful fan.

it might be related to incorrect CPU voltage settings on the motherboard

Another cause is mentioned at waynescomputerworld.com which suggests disabling the external cache if the problem happens during installation. Sounds like a good solution since there have been timing problems with AMD CPUs.

If all else fails try changing the CPU speed to a slower value and see if the problem goes away.

I'd try the first suggestion, reboot, and if it persists go to the second, and so on.

Good luck,

Maxwell

by zlitocook

Also check the on board video VXD probems are sometimes video related. Try a newer driver for it or disable it and try a pci video card to see it goes away.

This discussion is closed to new replies.