Windows Forum

Ask something
Discussion Locked

Error 711

0 helpful
2 replies

by shizmoney

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I need help

I recently installed a clean version of windows xp my computer which I wiped the drive. After installing xp I went to setup my new verizon dsl, but I found out that my line wasn't gonna be ready for a couple of weeks so I unistalled all the verizon and dsl software and i was just gonna create a dail-up account in the interim. But when I go to create the dail-up account I get this error 711 saying that I don't have the rights and cannot load Remote Access Service Connection Manager. So I go into services to start the RASCM and it still says that I don't have rights when in fact I am the administrator and the only account on the machine. The machine is a gateway
p3, 128megs of ram, running Windows xp.

2 replies

by joseph moore

Microsoft Knowledge Base Article - 330163

"Error 711: Cannot Load Remote Access Service Connection Manager" Error Message When You Create Network Connection
The information in this article applies to:
Microsoft Windows XP Professional
Microsoft Windows XP Home Edition

This article was previously published under Q330163
SYMPTOMS
When you try to create a new network connection, you may receive the following error message:

Error 711: Cannot load Remote Access Service Connection Manager.

The Routing and Remote Access service terminated with service-specific error 711 (0x2C7)
Incoming Connections depend on the Routing and Remote Access service which was unable to start. For more information, check the system event log.
Youmay also be unable to install network adapters.
CAUSE
This issue may occur if the following services are disabled:
Telephony
Remote Access Connection Manager
Remote Access Auto Connection Manager
RESOLUTION
To resolve this issue, enable thedisabled services, and then start the services:
Click Start, right-click My Computer, and then click Manage.
Double-click Services and Applications, and then double-click Services.
Right-click Telephony, and then click Properties.
On the General tab, click Manual next to Startup type.
On the General tab, click Start under Service status, and then click OK.
Repeat steps 3 - 5 for Remote Access Connection Manager and Remote Access Auto Connection Manager.

This discussion is closed to new replies.