Windows Forum
Every now and again I receive an error, "Unable to connect a second time to datasource." This has occured on two machines. There is no pattern to these error messages.
Both Windows NT and Windows 95/98.
by mike
Well not much info to work with other than the datasource. This is an ODBC error message. Go to your control panel and click on the ODBC configuration. View all your "active" datasources. A program that you have installed, has setup and ODBC datasource that may be timing out sometimes. If you are positive you aren't using any for apps, then go to each one and increase the time out. Or remove the drivers
Good Skill
Mike
by robert.brown
by robert.brown
This discussion is closed to new replies.
Sort by Trending