Discussion Locked

Ethernet connection for cisco 2600xm

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

my company is setting up a co-loacation for production machine. the co-location consist of 4 servers. one will function as SQL server, one is going to be primery web server and the other 2 are web/mail servers. the ISP is going to dedicate 1MB Ethernet bandwidth for starter. we have cisco2620XM. we have to connect to thirer to
thier router. the Eitehrnet card I found was the NM-1E but according to cisco spec that card operate at 10 base T. the question is will that be enough?

3 replies

by mshavrov

Sure :-) You will have only 1Mbps from provider, so 10Mbps to Server is 10 times more than enough. Only thing when you may need 100Mbps - if you have router in-charge of routing between 2 or more 100Mbps LANs (for example, with 2 FastEthernet interfaces, connected to different LANs.) In all another cases it's adequate. Some ISPs even forces FastEthernet interfaces at 10Mbps on propose. So, don't worry about router. You should only consider bandwidth and traffic BETWEEN servers on the LAN.

Good luck.

This discussion is closed to new replies.