Question Locked

Exchange 2003 on W2k3 - setup did not integrate in domain?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I just set up a new Domain on a new W2k3 standard server running DNS, DHCP. Set up another new W2k3 server with Exchange 2003 and performed all the checklist setup steps. Setup says it was successful.
When I add a new user to the domain, the wizard says it will set up a POP3 mailbox among all the other regular stuff. It does not mention an Exchange mailbox. when the user setup is completed manually, there are no Exchange Tabs on the user properties.
I am clueless as to why. I've never had this problem before. NETDIAG and the other tools report all ok.
Your input would be appreciated.

3 replies

by churdoo

From which server do you add the new users? From your AD controller, I presume?

Notice that on your exchange server, the exchange setup installed ADUC on the Exchange Server, which does include the Exchange Tabs.

To get the exchange tabs and functionality on your DC, put the Exchange Install CD in the DC and begin the Exchange Setup -- install the Exchange Administrative Tools (I think that's what it's called). Essentially, this adds the exchange tabs to the ADUC on the DC so that you have the full administrative functionality on your DC.

When you service pack exchange, remember to apply the same service packs on the DC's where you've installed the administrative tools.

by kwatson51

Thank you very much, I'll check this out tonight.

This discussion is closed to new replies.