Question Locked

External 1TB drive no longer detects the same

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a 1tb external USB WDC drive and earlier today it stopped working properly.

It spins up just fine but when it shows up under my drives it no longer has the assigned label and letter "I:BigUSB". now it just calls itself "H:local disk" and reports 0 bytes.

Weirder still is when I plug in my USB SD reader (which usually holds H:), the 1TB drive no longer detects as a valid USB device.

This has worked for two months flawlessly and has over 400GB free. Nothing is irreplaceable fortunately but a lot of time will be lost if I cannot recover the drive.

Any help anyone can offer would be appreciated!

4 replies

by oh smeg

Under Windows, the Partition Tables on the HDD have been corrupted.

If you look under Drive Management here for this HDD you will find that it asks you to perform a Format to use the Drive. So if nothing is irreplaceable you can just format the Drive and then start from scratch.

However if you want to try to recover your Data there are several options. You really need a Data Recovery Program that will rebuild the Partition Information on this drive. I've been told that File Recovery works for this issue but I've never personally used it and it is a Pay For Application.

http://services.seagate.com/promotion1.aspx

However On Tracks Data Recovery Software defiantly works a treat but it's not the cheapest option available.

http://www.ontrackdatarecovery.com/data-recovery-software/

I've been told that Spin Rite is a popular Recovery Application and it's not too expensive

http://www.grc.com/sr/spinrite.htm

Another popular application is Get Data Back

http://www.getdata.com/

But I have no personal experience with this application.

However if you do have any Important Data involved here you would be better not doing anything but send the Drive off to a Data Recovery House and let them recover the Data. If you mess with it and still need to send it away it's going to cost you far more and you run the risk of permanently destroying data.

When you get the drive working again [b]ALWAYS[/b] use the Safely Remove Option in Windows and shut off the drive while the computer is running. [b]Do Not[/b] expect the computer Shut Down Procedure to safely turnoff any USB Devices.

Col

by smokeytheblair

You're certainty a wealth of knowledge! =)

When I first got into removable hard drives I figured I'd be using the Safely Remove Hardware option a lot but I looked online and found many people saying it was not necessary, and the impression I continued with for some time.

I now know better. Thanks for your advice!

I did manage to get the drive working again around 5am by using Partition Table Doctor to rebuild the partition table, just as you said would have to be done. It's an absolutely amazing piece of software which was also able to repair some damage to my internal drives I didn't even know about.

Thanks very much for responding so quickly too! From this point on I'll be using the proper ejection procedure to remove my external drives!

This discussion is closed to new replies.