Question Locked

external hard drive problems

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an external 120GB HDD, you know, one of those cigarette packet sized devices that basically is a laptop HDD in a case. Worked perfectly until recently when it would not open. Anyway it has about 80GB (mostly old scanned photos)of information on it. When I plug it into the laptop (compaq 2500 running XP) the machine slows down, diskmanagement eventually sees the drive after 50 mins (oh! by the way you have to rescan to get this far) but it shows 111GB free and no other data present. It allowed me to change the drive letter but that didnt change the outcome. When I remove the device the screens clear and the laptop is back to normal. I have tried just about every solution I can find on the net. Can anyone help?

7 replies

by thumbsup2

Do you have an external power supply for the HDD case, or are you trying to power it through the USB connection to the laptop?

When it ran right, did you leave it plugged in all the time, even when shutting down the laptop and/or powering it up?

If you unplugged it while the laptop was running, did you use the Safely Remove Hardware icon to stop it before you unplugged it from the laptop?

by m61a1

Used the safely remove icon all the time. always removed before power down.
power is through the usb connection and there are two on the lead.

by oh smeg

Open the Case and remove the Drive. Fit this to either a USB or Firewire Enclosure and see if it works now. If it does then copy your Data off it and save it somewhere where it will not be lost.

If the drive still doesn't work I need to know if this was left running all of the time or just used when it was needed to copy data to. If it was left running all of the time that the computer was then you can quite rightly expect the Drive to have overheated and damaged the Electronics on the Circuit Board on it's bottom as well as the Electronics in the USB to HDD interface.

You also should have an external Power Supply for these Drives and not rely on the Computers USB Port to supply the Current at 5 V DC to correctly run this drive, What happens is that quite often the USB Ports do not have sufficient Current to run one of these devices so it is constantly running in a Under voltage Mode and this burns out any Motors in the device. As this is a HDD there are 2 Motors involved here the First one spins the Platters at a constant Speed and the second one moves the Read/Write Heads across the face of the Platters inside the drive. In a low current Configuration the Platters are not kept to a regular constant speed and the Read/Write Heads are not accurately moved across the platters so you get Errors occurring in any Read or Write Operation.

The other thing you need to know about these drives is that they should be shut down prior to the computer being turned off or the Lead Unplugged and under no circumstances should the Enclosure be moved till the drive Platters have stopped spinning even if you are positive that the Read/Write Heads have been parked. To turn off any External HDD you should use the Safely Remove Option on the Task Bar near the Clock and then when prompted unplug the lead then wait for the drive to actually stop before moving it.

If you just turn off the computer or unplug the lead eventually the Partition Information will be Corrupted and you will have effectively lost any Data on the Drive at that point.

Now if this is [b]Important Data instead of just being Nice to have[/b] you should send the drive off to a Data Recovery House and get them to recover your Data expect a minimum of $900.00 for a quote for the recovery and anything up to about 150K after that if you give the go ahead. The faster that you want it back and the more you do now to mess it up the more it is going to cost to get recovered and the more likely you are to get a Incomplete Recovery as well.

But if this would just be [b]Nice[/b] to have recovered you can try one of the many Data Recovery Applications available here is a short list of the better ones but it is by no means a complete list of what is available.

http://tinyurl.com/273ay5

http://tinyurl.com/rmvrv

http://tinyurl.com/yvrsl

http://tinyurl.com/yyk8cm

http://tinyurl.com/382vm

http://tinyurl.com/ynwnel

http://tinyurl.com/nc4kx

http://tinyurl.com/2wox7l

http://tinyurl.com/374d8b

http://tinyurl.com/djw6u

http://tinyurl.com/f73se

http://tinyurl.com/8bd3f

http://tinyurl.com/afu2j

While the last 2 are from the same company they are very different products. Win Hex should only be considered for use by someone who knows Hex Inside Out while Davory is a great cheap General Purpose Application.

Personally I prefer the On Track Option but it's anything but cheap. However because I use this type of software a lot it's paid for itself many times over by now, for a cheaper option Spin Rite from Gibson Research or Stella have both very good reputations by other TR members.

Col

by m61a1

whats a firewire enclosure?

hdd was only on for the time to download then removed using the safe remove icon. You can hear the disk spin, lights change colour and a high pitched zipping from inside the case, I presume this is the data reader moving.
The thing is I know there is data on the hdd but it shows as empty on disk management. Then when you try to open the folder it says it cannot open.. puzzzling!

by m61a1

Are there any free software packages that will recover data?

by oh smeg

Yes there are but as I have no experience with them I don't know how well they will work.

What you need is something to rebuild the Partition Information and this may work

http://www.thefreecountry.com/utilities/datarecovery.shtml

But as I have no experience with any of these so if it doesn't work you may be in a worse position that you currently are. If things go wrong here you run the risk of loosing it all.

Col

This discussion is closed to new replies.