Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
l have an iptime wireless broadband router pro 54g.l have connected it on company lan modem and am trying to configure it so that l can access internet from my laptop using xp SP3 via wireles.from the company modem to iptime router wan port its a straight through cable and from iptime router to laptop its either wireless connection. router default gateway is 192.168.0.1, if l ping it is reacheble but if l try to acces the initial login page from the router the page is not rendered. what am l supposed to do please help?
3 replies
by darmpofu Accepted solution
Clarifications
by oldbaritone Accepted solution
Usually, to do configuration you must plug the hard-wire cable into the router. Many wireless devices do not allow configuration changes from the wireless port.
Try plugging a hard-wired computer into the iptime router, and reboot the computer. Then set the configuration for the iptime.
When you are done, plug the hard-wire computer back where it is supposed to be, and reboot it again.
by oldbaritone Accepted solution
bumped into the Post button. sorry
:-(
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Locked
Internet connection perfect on PC, not connecting anywhere else
0 helpful
4 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies