Fast Ethernet port Problem
Hi All,
In Cisco 2621XM router one fast ethernet is working with only 10Mbps speed. its not working with 100Mbps speed. Pleas guide me to solve this issue.
Mail me : yusef2006@gmail.com
Regards,
Yusef
Networks
Hi All,
In Cisco 2621XM router one fast ethernet is working with only 10Mbps speed. its not working with 100Mbps speed. Pleas guide me to solve this issue.
Mail me : yusef2006@gmail.com
Regards,
Yusef
by yusef2006 Accepted solution
by jim babay Accepted solution
1) Check through the Cisco management software if the port happens to be set to work at 10Mbs.
2) Verify that the device in use on the port operates at 100Mbps.
3) Try power cycling the router to see if it clears up (I've had different dual speed ports on devices get stuck on one speed get cleared on this).
4) The port may have gone "bad".
by yusef2006 Accepted solution
Thank you for your stuff. It only working when speed set to 10Mpbs, if i changed the speed of interface to 100Mbps it not working i.e i can't ping to the router interface.
Simple Example I tried.
I connected the router to PC via cross-over cable to tha fastether port. I can ping when the speed i set to 10Mbps on both size. if i change the 100Mbps on PC and Router its not working.
Please guide how to do power cycling the router.
if port is gone "bad" then wht is solution?
Thank you again for your support
Regards,
Yusef
This discussion is closed to new replies.
Sort by Trending