Question Locked

Gateway Essential 500 won't recognise hard drive

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My gateway system won't detect my 10 gig hard drive. I previously put a 250 gig hard drive in but that was dodgy and kept freezing when i logged in. now i want to use my 10 gig hard drive but wont recognise it in the master jumper settings.
it registers it in slave mode. Everything was working fine until i stuck that 250 gig in. Now it only registers the 250 gig now! thats after i've tried and tried to get the 10 gig working.
Please help!

3 replies

by older mycroft

Presumably the Master hard drive is the unit with your OS mounted on it.

[i]"..now i want to use my 10 gig hard drive but wont recognise it in the master jumper settings. it registers it in slave mode."[/i]

So where is the problem?

by oh smeg

Have you altered the Jumper setting on it to Master?

It sounds very much like the Jumper on this Drive is Set to Slave or maybe CS Cable Select and then it is on the Slave Plug on the IDE Lead. To force it to the Master position you need to set the Jumper to Master. There should be a sticker on the HDD with the Jumper Settings on it.

This can be on the Main Sticker that has all the details of the HDD itself or in a secondary Sticker near the Jumper Pins located between the Data & Power Sockets on the HDD. Or it may be on the Bottom of the HDD depending on the make of it.

Col

This discussion is closed to new replies.