Question Locked

graphics chip set died. can it cause repeated restart loop in normal mode??

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Toshiba Satellite m45 s3553 and it keeps crashing in normal mode. Safe mode, Safe mode with networking and safe mode with command prompt all still work perfectly fine (with the slight exception that it takes about 5 minutes for mup.sys to load) ive checked my installation of XP home SP2 and its ok (even if i boot from cd to ubuntu live it crashes), and ive tried 2 different hard drives and i still get the crash, the only thing ive noticed is that occasionally if i troubleshoot and turn the graphics accelerator all the way down it lasts a little longer before it crashes. Ive tried using my system restore disk to no avail also. my system is as follows (or atleast as much as i know how to tell you, any instructoins on getting a more detailed list would be appreciated):
Microsoft Windows XP Home edition version 2002 SP2
Intel(R) Pentium(r) M processer 1.73ghz 798MHz, .99gb ram

the graphics chipset in mention is the Mobile Intel(R) 915GM/GMS, 910GML Express Chip Set Family.

i hope this is enough information, is it possible for a faulty graphics chipset to cause this type of reaction on a computer?? and if so, is there a way to make Normal mode act like Safe Mode with Networking....WITH SOUND?

any help would be greatly appreciated... i dont have the money to buy a new computer right now, so im trying to prolong the life of this one until i have the money...
Thanks
Tim

5 replies

by ic-it

Since it crashes even with a live CD, but not when the graphics is ratcheted down.
Verify that your exhaust fan(s) works and the ports are not blocked.
Possibly the heatsink has become loose on the graphics chip/card?

by cg it

Tt could be your graphics card drivers. Safe mode doesn't load up the installed graphics card drivers which is probably why your comp works in safe mode. try uninstalling the graphics card drivers in safe mode. Reboot to normal mode. see if that fixes the problem.

by tintoman

This problem could be caused by either overheating or graphics drivers, when you start the computer in safe both only the basic set of drivers are loaded and therefore the processor has little work to do, in normal mode the processor works a lot harder and becomes hotter, so if the cooling system is not functioning properly you will get a shut down.
Check the heat sink and airways on the cpu and fan, and clean if necessary, then I think all will be ok

by globalastro

I had gone in and uninstalled the drivers but it didnt make a difference... also, safe mode was letting me change the screen resolution (not normal) but it doesnt matter anyways, both of my hard drives are now not reading in my laptop... so it seems i will just have to go buy a new computer.. thanks to everyone for the help, i really appreciate it..

This discussion is closed to new replies.