Question Locked

HAL error

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I receive the following message when starting a Windows XP Professional with SP2 machine.

"Windows could not start because the following file is missing or corrupt \system\hal.dll. Plese reinstall a copy of the above file."

This message appears during restart of the computer, before the Windows GUI begins to load.

Any help is greatly appreciated.

5 replies

by wesley.chin

Correction to the path.

I receive the following message when starting a Windows XP Professional with SP2 machine.

"Windows could not start because the following file is missing or corrupt \system32\hal.dll. Please reinstall a copy of the above file."

This message appears during restart of the computer, before the Windows GUI begins to load.

I am seeking to avoid reinstallation of Windows.

Any help is greatly appreciated.

by rob miners

If the system fails to boot, the following method of recovery is not possible. There will be a fault with

the Hard Drive. It is probably on its way out. It may be a good time to remove it from the PC and connect

it to another to retrieve your information. Unless your Backups are up to date.

Boot the Computer From the Windows XP CD and Start the Recovery Console

Insert the Windows XP CD into the CD drive and restart the computer.

At the Press any key to boot from CD prompt, press the Spacebar to display the Windows Setup screen.

Press the R key.

If prompted, select the number corresponding to the Windows installation you want to log into (usually

C:\WINDOWS).

Press the Enter key.

Enter the Administrator password, if any, and press the Enter key on the keyboard to display the

C:\WINDOWS> prompt.

At the C:\WINDOWS> prompt, type cd \

Press Enter.
The prompt changes to C:\>.

Type bootcfg /rebuild.

Press Enter.
The following messages appear:

Scanning all disks for Windows installations
Please wait, since this may take a while...
The Windows installation scan was successful
These results are stored statistically for this session. If the disk configuration changes during this

session, in order to get an updated scan, you must first reboot the machine and then rescan the disks
Total identified Windows installs: 1

[1]: C:\WINDOWS

Add installation to boot list? (Yes/No/All) appears.

Type y, and press Enter.
Enter Load Identifier appears.

Type one of the following that pertains to your system:

Windows XP Home Edition for Windows XP Home Edition
Windows XP Professional for Windows XP Professional
Windows XP Media Center for Windows XP Media Center

Press Enter.
Enter OS Load Options appears.

Type /NoExecute=OptIn /fastdetect and press the Enter key.
The C:\> prompt returns.

Remove the Windows XP CD from the CD drive.

Type Exit, and press the Enter key.

The system boots into Windows XP.

by sauravrohilla

you can try last known good configuration, i m not sure if it gonna work as system hal file is missing..

This discussion is closed to new replies.