Discussion Locked

HARDWARE CONFLICT/IRQ SHARING

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am currently running Windows 98SE along with MS Office 2000 Pro. I recently installed a PCI USB card and have installed a PCI internal US Robotics modem. I have a HP scanner connected to the USB port. I receive error that scanner can't be initiated and the modem says the port is open and can't connect. My system has given the USB port and the modem port the same IRQ10 position.

I have tried to change the resource settings of the USB and modem but my system says that they can't be changed.

Can you help me with this problem?

Thank You

9 replies

by fred07

May be possible in bios to change IRQ's or in device manager. Check in my computer properties for the conflicting devices and it should tell you the fix also. My bios allows for IRQ settings and keeps win out of it. It is the hardware profiles tab.

by regarchrm

Thanks, but as I stated, I am not able to change the resource settings according to my system error notice.

by dusty1one

Try removing the modem and see if the scanner works. If the scanner does not work, then remove the USB card and test the modem. If the modem works then reinstall the USB card without the scanner. Go into the Device Manager and see if there are anyconflicts. If not, try the modem to ensure it is working then connect the scanner. If this causes problems, then goto device manager and select the modem and try to change the irq setting under the resources tab. You will need to uncheck the "UseAutomatic Setting". Reboot and try again.

by regarchrm

Thanks, but as I stated, I am not able to change the resource settings according to my system error notice.

by regarchrm

Update: I've uninstalled and reinstalled both the modem and USB port several times and still have conflict, although Windows says that there is no conflict.

I believe that I need to change the IRQ setting of either the modem or USB port so that they do not have the same IRQ setting (IRQ10). Windows will not allow me to change the resource settings.

Does anyone know of a work-around so that I can change the settings?

Thanks

by d_v ant

Motherboards share IRQs between PCI slots. Sometimes, the only way to seperate tehm is to try each card in a diiferent slot and check BIOS to see which IRQ was assigned. Some PCs have one slot that is not shared. See your motherboard or PC manufacturers documentation for which slots are shared.
If you do not have the documentation or cannot find anything at the manufacturers website, the only thing left is experimentation.

This discussion is closed to new replies.