Question Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hello everyone. WEll just last night i was trying to install windows on my computer and my disk was currupted couldn't load all the files so i went to the store and came home tried to restart comp and got nothing no pic no nothing. opened up and my hard drive wasn't kicking on untill i unplugged the ide cable then it kicked on. Found that it was the same for my cd drive as well WHat could the problem be? Ive tried diff cables, power supply,hd. still same effect?
2 replies
by vladamir6969 Accepted solution
Clarifications
by thechas Accepted solution
Well, either one of the IDE cables is plugged into the motherboard backward.
Or, one of the drives has the jumpers set wrong. If the cable connectors are labeled master and slave, then it may be a cable select cable and both drives should be set to cable select.
If you do not have a cable select style cable, the drives on a common cable should be set to master with slave present and slave.
If there is only one drive on a cable, it should be set to master or single.
It is also not impossible that either a drive has failed, or the IDE controller on the motherboard has failed.
Chas
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies