Question Locked

HDD enclosure trouble

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My old computer had some difficulty, and it was a bit of a hassle to fix it, so i decided to pull out the hard drive and use an enclosure to transfer the data once my new laptop arrived. The laptop showed up, i set up the drive, switched it on, and nothing. The Laptop ran on vista home premium, and DID install the drive, but 'Computer' either doesn't recognize it or Explorer slows way down trying to. I unplug the drive and everything is back to normal. I tested the drive on a desktop computer, and it took a while to recognize, but once it did, it gave me this error message:

E:\ Is not accessible
The request could not be performed because of an I/O device error.

So, from this point, what's the easiest way for me to recover my data? Is there something i can do to fix this unrecognizable enclosure? Or some alternative to my current recovery method?

thanks for any help in advance

4 replies

by chris910

Most of the External enclosures Require that the Drive be configured as master and not cable select or slave.

by melanieharv

This was the exact problem for me, and all my data was on the drive I pulled from the previous computer. Popped the jumper into master and vista found it immediately.

i can't thank you enough.

by oh smeg

If you have a conventional 3.5 inch drive it needs to be set to Master but if you had a NB Drive you need to remove every jumper from it before fitting to an external enclosure.

If you can not access your old data you will need to post back with what the version of what OS you are running and someone may be able to help you from there but as most IT Pros are yet to start to support Vista you may have some problems.

Col

This discussion is closed to new replies.