Question Locked

Help!

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My Toshiba laptop Satellite A105-S2081 had 40GB Toshiba hard drive. Week ago my laptop did not boot up and after several attemps I tried to restore factory default through CD provided by Toshiba. It could not restore Factory default with error message.

I ordered new Samsung hard drive of 320 GB and installed it but upon boot up this hard drive is not recognized. My laptop freezes at the initial Toshiba screen.
How do I make my new hard drive recognized during boot up.
Is there any else required for installing new hard drive?

7 replies

by oh smeg

I don't think you can. This is because BIOS has a Upper Limit built into it and you can not exceed this Limit and have a working computer.

If you remove the HDD and look at the Sticker on it in comparison to the one on the Toshiba HDD see if the Current Consumption is the same. It is possible that the 320 GIG Drive draws more current than the 40 GIG Drive and this computer [b]Can not[/b] supply that current.

With NB's you not only need to look at the Size that can be supported by the BIOS but the amount of Electricity that the Drives use because NB's run on batteries and they have limited amounts of Power & Current Available.

Also look at the HDD Connector there are a group of Pins that are not connected to the M'Board these are for fitting a Jumper to and you need to look at the Old HDD to see if it had a Jumper on it or not. You need to set the new HDD to the same configuration as the old so if it had a Jumper you need to fit one and if it didn't and your new one does you need o remove the jumper.

While you may be able to limit the drive to 32 GIG with the fitting of a Jumper it will still require the same amount of Power to run correctly and this will not be available so even if you got it to work in this NB it would fail far sooner than it should.

Col

by older mycroft

I may be wrong in this, but I've never heard of a 40GB SATA drive.

This discussion is closed to new replies.