3 replies
by kamillun bios Accepted solution
by ic-it Accepted solution
and the jumper while your inside.
Sometimes bootable media will only load if it is coming from the device on the master position of the IDE cable.
If he installed the HD as the master and the CDROM as the slave, get another cable and use the CDROM as the last I.e. Master position) device on it's channel.
Verify that it's jumper is set to either CS or Master.
by thechas Accepted solution
What version of Linux do you have?
Is this a live version or an installer?
On the presumption that you downloaded Linux from the web, how did you burn it to the CD/DVD?
In order to boot from a CD, the CD must be burned as a bootable volume. Most "ISO" file distributions when burned to a CD as an ISO image and not just the file will boot.
If the Linux file you have is a ZIP or EXE file, it will not be able to boot your system from just the files burned onto a CD.
There should be documentation at the home web site for the version of Linux you have on how to create a boot or install disk.
Keep in mind that installing Linux WILL require that the hard drive be formatted! Make sure that you have backup copies of any data files that you stored on this computer.
Also, make sure that the hardware you have is above the minimum requirements for the version of Linux you wish to use.
Finally, make sure that you can get Linux version drivers for your hardware.
Chas
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending