Question Locked

HELP - PCU, Motherboard, Power Supply or Case is dead ?1?

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi dear reader,
Weeks ago I built my first pc.
It worked just fine for 4 beautiful days. One day when I walked into my room and moved my mouse I discovered that my pc had turned off?! It would not start up again since then. The ONLY thing that does happens is that my fans (all system fans, videocard-fan and the cpu-fan) give a short reaction by making a few spins when I press the power button. Furthermore It doesn't beep, nothing.

To minimize the possibilities I have tested the parts that should make the system run:
psu, mobo, cpu, cpu-fan, power-sw, reset-sw.

I have tested my pc with parts from a friend.
These are the results from what I've tested:
My cpu + other mobo, other psu =working
My mobo, case, psu + other cpu =nothing happens
My mobo, case, cpu + other psu =nothing happens

My only conclusion is that the cpu is working!
Unfortunately I could not test my power supply in his system.

I thought that it must be my mobo but...
I allready returned my mobo twice (received new ones), and now bought (the same) one from a different company so it is not very likely that I have received 3 bad mobo's!

Can it be the power supply, although the fans give a reaction? Can it be that the case shortcuts? Is my power-switch or reset-cable broken? I am getting very desperate! ;)

I really need the pc for my study.
Any help will be greatly appreciated!!!

Greetings from Holland,
Bart

9 replies

by thechas

Well, depending on what was wrong with your other motherboards, it is possible that you there are design or manufacturing problems with this specific motherboard. Having 2 bad boards already is significant.

You can get power supply testers for as little as $10 (US). While not a full test, they will show up a dead or malfunctioning power supply.

Another option is to check around for local independent PC shops and see if they will test your power supply.

If you buy some parts from them, they should be willing to test your other parts.

Chas

by ashell.b

I am actually having this same problem. I woke up 1 morning and it just wouldn't turn on. The power light stayed on, the fans did a quick spin, but in half a sec there was no motion. Later I went to turn it on and it started right up. Next morning it wouldn't start. Its usually stays running but there are a few times when it has shut off during use.

I can't tell if one of the rails on the power supply has gone bad, or if the mother board has a loose solder joint, or its tripping some sort of over heat protection cold.

I'm poor and under-employed so I would like to get this resolved as cheaply as possible.

I have an intel D945GPM with intel 840 chip and ultra xfinity 500 PSU.
Single stick 1 gig generic ram and nvidia 7900GS.

by w2ktechman

it may just be that the MB isnt seated properly and may be shorting out, or the ground is not good enough. Make sure to ground it well.

by ashell.b

I think you may be on to something here! I have been checking connections all morning and nothing helped.

I took some copper wire and shorted a grounding point to the case (just for a moment) and it turned right on. I loaded up a game though and let it really draw some power and it clicked off again.

So I guess I dont really understand. My MB came with little isolating plastic rings when screwing down the motherboard, should I not use those plastic washers? This still makes me think the power supply is unhealthy in some way or another because there should be more than 1 ground on the 24 pin connector.

I'll do some playing with it to see if its 100% that a short will make it power on.

by thumbsup2

There should be at least one screw holding the MB to the case that does not use the plastic rings and screws into a metal spacer attached to the case. That's what completes the ground. One ground on the 24 pin connector is sufficient, as long as the circuit is complete.

by mjd420nova

This sounds exactly like anyone of a hundred units I've looked at. The most common fault is the missing or dislogded insulating spacers on the underside of the MOBO. I always use plastic or nylon standoffs to eliminate this as a failure. The washers can become dislogded or even not installed at all. There should be sufficent grounds provided by the connector from the power supply. The fans trying to spin and then stopping is the power supply protecting itself from a short which is normal when a short is sensed by the 12 volt or 5 volt supply. The situation where it runs for a while and the shuts off is caused by the heat allowing things to grow and short after a short period. Check it out by removing the MOBO from the case and install just the video card. If it starts okay, then start adding drives and other cards to determine if another card is shorting or overloading the power supply. Once you've located the fault you can put the MOBO back in the case and start with just the video card again, adding cards and drives to confirm what's shorting out.

by ashell.b

I opened up the power supply and it looks like some vinyl insulation had melted or worn away. I fixed that up and it starts up just fine warm or cold.

The MB to case ground had nothing to do with it I guess.

Thanks to all who replied.

This discussion is closed to new replies.