Question Locked

Help with Dell Optiplex GX50 - bit off more than I can handle.....

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

So, I bought a refurbished Dell Optiplex GX50 which came with no OS and no CD-ROM drive. I have installed both an OS and CD-Rom drive before so was confident I could do it. Well, it seems I overestimated my abilities! LOL The Bios settings only has boot options for the C: or the floppy drive. So, I can't figure out how to get the CD Drive installed pre-OS. I find on Microsoft's webpage where I can download XP onto 6 floppy diskettes. Great, downloaded them and try them and on disk #2 I get an error message and according to the info I find, I need to reset the Bios to factory settings or the memory stick is bad. So I swap out the memory and I still get the error message. I don't know how to reset the Bios to factory settings and I don't know how to install a CD drive pre-OS so that I can install the OS from my disk? Oh, I also had a old Win98 boot disk that asked me to start with cd support and it said no valid drives were installed. Any ideas? I feel like I'm missing something really obvious but don't know what it is. This computer really only needs to surf the web and do basic word documents. It's mostly for my kids. Thanks for any help you can offer!

Nikki

5 replies

by older mycroft

The BIOS won't see it if it's NOT connected.You don't have to tell the BIOS what you are going to install - the BIOS tells you what it can 'see'

Also, the 6-floppy version of XP is NOT a full install, it is only a Recovery set for systems that can't initially boot from optical disc. ;)

by nikki

Yup, I've tried 3 different drives I have here. One is a DVD drive but the other two are just old CD drives (one R/W and one just Read only). All three are known to work in a different desktop. They get power (the door open/close) and they spin for a bit but I can't figure out how to read that drive? That is the part I think I'm not getting.

I know the 6 disks were just a recovery. I have a full cd install, I was just hoping they would install enough so that I could get the system to 'recognize' the cd drive when I install it...

Hope that answers some stuff I left out.

Thanks for the response.

Nikki

by 1bn0

The bios may be set to "skip" the unused IDE ports. It may ignore the cdrom drive if the bios is not set to scan for the device.

If you can set the other IDE ports to AUTO.

If the BIOS does not "see" the cdrom drive during boot, than nothing else is going to either.

by rob miners

If you look at the IDE Slots on the motherboard you should see in fine print something like IDE0 or IDE1, or IDE1 or IDE2. When you work out which one is the lowest number that will be the one to connect the hard drive to.

Primary IDE Hard Drive is on this channel and the drive is jumpered as Master and is on the end of the IDE cable

Secondary IDE CD/ROM Drive is on this channel and the drive is jumpered as Master and is on the end of the IDE cable

Some reading material.
http://support.dell.com/support/edocs/systems/opgx50/en/UG/advfeat.htm#1131301

http://support.dell.com/support/edocs/systems/opgx50/en/UG/specs.htm

This discussion is closed to new replies.