Question Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a building wirelessly connected to another building. Routing of vlan's and dhcp are done on a cisco router in the first location. I have since set up wireless access points in both locations and cisco wireless controllers in both locations. I am running out of IP addresses at both buildings. My wireless technician says that I can only pull IP addresses from the wireless controller on the same subnet. I need a resolution to this as I am running out of IP addresses when a wireless device attaches to the network. Any ideas appreciated.
2 replies
by treavis Accepted solution
Clarifications
by tomnegele Accepted solution
Depending on your class of addressing, and what your mask structure is, you can redo your wireless network, to have more hosts, for your subnet. For example, if you had a class c, with a default mask, you would have 254 usable hosts.
However, if to used a class a, 10.0.0.0 network, using a 16 bit mask, you would have over 32000 hosts available. The 10.0.0.0 network would have to be nat -network address translated- to that which you have registered for routing to the internet.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies