I am no computer expert but i can tell you how i fixed my problem.
About a month ago i got an Acer Laptop which has a Broadcom wireless adaptor built in. Its my first laptop so i was messing about with it connecting to my main pc, that it cable connected to my D-link router, like ya do when ya get a new toy.
I then discovered Remote Desktop and this is when things went down hill.
I am running XP on both my machines.
I installed the Remote Desktop on my laptop and noticed it was different to my Main Pc. i thought nothing of it at first and everything was fine. I could connect to my main pc with the laptop on wireless no problem.
I was only connecting to my main pc using the local IP address(192.168.0.100) through remote desktop. I then decided to connect through the IP that the Router uses to access the internet. To do this i had to change the port number for Remote desktop to listen to. Before i did this i upgraded to XP service pack 3 so that the Remote Decktop was the same on both PC's. When my Laptop booted up after the service pack installed everything was ok. I then changed the port number.
That is where my problem is.
Every time i tried to connect using my wireless on the laptop it kept hanging on acquiring network address. I tried everything i could think of to correct the problem but i had no success. I put i down to the new service pack install so i uninstalled it. Everything was fine and i got my wireless connection back.
The funny thing is, is that XP service pack 3 is NOT the problem. But i cured my problem so i was happy.
I did not try the Remote Desktop again until tonight.
I have only sussed the problem tonight because i am going away for a few days with work tomorrow and decided to take my laptop as i have a six hour train journey.
I tested the RDC to see if everything was ok as i might was to access my main pc when i was away. It didnt work.
What i discovered is that when i removed service pack 3 it reset the RDC listening port back to its default(3389).
I have found that if i change the port number on the laptop the broadcom wireless adaptor can not acquire an IP address. I also have a netgear wireless adaptor that runs on its own software and that works fine when i change the port number from the default.
My problem is with the broadcom Wireless adaptor.
In a nutshell if i keep the default RDC listening port everything works fine.
Hope this helps and let please post a reply if it does.